Taipan Laminate airgun

Uragans airgun

shroud advice

This topic has 4 replies, 2 voices, and was last updated 2 years, 4 months ago by stickbow.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
January 25, 2018 at 8:46 pm #23141

stickbow
Participant

i need some help in making a shroud for my condor. with a 12″ barrel, do i want the butt end to come right up against the front bushing? i have a piece of 1 1/2″ delrin to use.

January 26, 2018 at 8:27 pm #274046

rrdstarr
Participant

That is how I made mine for my TalonP. Vented(factory) bushing and Delrin is what I used to make the insert that replaces the end cap. Aluminum tube with .063 wall and K type baffles. Aluminum end cap.

January 27, 2018 at 2:22 pm #274053

stickbow
Participant

how did you do the K baffles? drill 45 degrees to the bore opening? what size did you make them?

January 29, 2018 at 3:18 am #274083

rrdstarr
Participant

Dimensions: OD .870″ .003-.005″ smaller then inner wall diameter. Hole is .030″ over diameter of the pellet/bullet. 45 degree angled hole. OAl length is 1″. Can’t show a picture here as it is against the rules.

February 26, 2018 at 12:51 pm #274411

stickbow
Participant

What size bit did you use for the 45 degree angles bored into? And how far apart do you recommend? Thanks!
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.