regulated Talon? CO2 adapter & 88ci carbon tank
new to Talon… please forgive me if this has been covered.
is it possible to convert Talon for regulated output?
a CO2 adapter should mate to a carbon 88ci paint ball tank.
HPA paint ball tanks are usually regulated from 600-850 psi. regulator spring can be modded for most any pressure desired.
has anyone already done this?
All Replies
Viewing 7 replies - 1 through 7 (of 7 total)
thanks… this could be a solution for a regulated talon.
already got the little carbon tank.. does anyone have an extra CO2 adapter for sale?
NICE pic Rusty! I didn’t know for sure how you shimmed the reg in there.
Very cool, Jim.
Yes, it is easy to bump up the pressure.
In a talon w 18″ barrel with a PB reg set at 1400 it will shoot about 770, very consistently, with 16g pellet. You do need to change out the 1.5K burst disk……ask me how I know.
Eric1200 on this forum has a Talon setup this way.
Rusty
I never modified the paint ball tank’s regulator myself, but some people suggested that it’s easy to increase the output pressure by adding an extra washer.
sirjeigo on here has a couple posts on here about it…might be someone else also but I remember his…I think it is in this folder too…he was getting some good performance out of his.
EDIT had remembered wrong guy it was sirjeigo who has the setup…
Jim.
Viewing 7 replies - 1 through 7 (of 7 total)
- You must be logged in to reply to this topic.
I would suggest the new benjamin sheridan tank for the discovery. It outputs 2000 psi. I eagerly wait for this to be available in canada.