Taipan Laminate airgunUragans airgun

Need the special tools, for O rings

Home Forums General Mods/Machinists Need the special tools, for O rings

This topic contains 1 reply, has 1 voice, and was last updated by  rrdstarr 1 year, 10 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #23003

    iride
    Participant

    I need the special tools for putting in O rings in PCP guns,
    I used all kinds of crap trying to hold the Oring to install in my Mutant 22 ,
    Five hours to install two O Rings , and I screwed the gun up it will not cock,
    Screw drivers, Dentist tools, needle nose , tweezers, sticks sanded down to size,
    Fuck that shit,
    I need to order the special tools.
    Mike

    #272887

    rrdstarr
    Member

    Lots of machinist make a sleeve to slide o-rings on and off, especially over Sharp V threads. I use hooked scribes from Snap-On for removal.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Skip to toolbar