Taipan Laminate airgunUragans airgun

mutant exploded diagram

Home Forums BullPups Taipan Mutant/Veteran mutant exploded diagram

This topic contains 9 replies, has 6 voices, and was last updated by  iride 1 year, 3 months ago.

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • #22052

    cally88
    Member

    anyone have access to an exploded mutant standard and mutant short diagram?

    Looking for screw lengths of the HST set screw. I am fairly sure it is a M4

    also need a little clarification on the O-ring sizes
    from Dman in the o ring post…..
    21 X 3 Seal rear / front stopper tank 1 each and Regulator OD x2
    13.5 X 2 ​​Seal valve body
    12.5 x 2 ​​Seal the barrel on the receiver

    4.47 x 1.78, -008. (.177) Probe Seal x2
    5.28 x 1.78. -009. (.22) Probe seal X2

    9.25 x 1.78. -012. pressure gauge
    4.47 x 1.78. -008. filling nozzle

    23 x 1.5 (.177) magazine od x2
    1.5 x 24 (.22) magazine od x2

    Regulator.
    2.9 x 1.78 -006 Nozzle gear
    12.42 x 1.78 -014 sleave.
    6.07 x 1.78 -010 Piston reducer *Buno 70 polyurethane*
    2.9 x 1.78 -006 Piston reducer *Buno 70 polyurethane*

    are the above numbers in mm?

    Thanks.

    #262247

    gku
    Participant

    Yes that’s correct there is a post on O-rings for the Mutant above that is in mm also.
    The OAL lengths of the HST set screw is 5.8mm (#74) and it has a small nylon insert to prevent ware on the threads (#58).

    ~ Greg

    #262248

    cricket
    Member

    Is there a part 2 of that Greg? Where it says what the numbers are referring to

    #262253

    cally88
    Member

    :8:

    Thanks greg!

    #263266

    jp-over
    Member

    Great info; thanks!

    #270906

    humdinger
    Participant

    My fill probe started leaking. The list of O-rings shown in this thread and others all say the “filling nozzle” O-ring size is 008. However, this doesn’t seem correct based upon my probe. An 008 O-ring seems to be wider than the ones on my probe. I replaced mine with 008’s and it is too tight to fit into the fill port. Anybody know the correct O-ring size on the Mutant fill probes?

    #270907

    gku
    Participant

    1.78mm X 4.76mm

    http://www.theoringstore.com/index.php?main_page=product_info&cPath=368_12_43&products_id=16718
    My Mutant fill probe fits better into my Edgun ……… but both seem to be interchangeably used with each.

    ~ GReg

    #275313

    iride
    Participant

    I can not get the diagram to show up?
    Greg can you repost the Diagram.
    Mike

    #275315

    gku
    Participant

    Sure Mike no problem ………

    ~ Greg

    #275326

    iride
    Participant

    Greg
    Thanks a million ,
    Mike

Viewing 10 posts - 1 through 10 (of 10 total)

You must be logged in to reply to this topic.

Skip to toolbar