Leshiy Reg. factory setting
I messed up the reg. setting.
Can anyone remember the factory setting(130bar) of the reg. set screw depth? like 7.35mm?
All Replies
Viewing 4 replies - 1 through 4 (of 4 total)
Factory set 130 bar depth of the adjustment screw on my gen 2 leshiy regulator is 0.218″. Hope that helps.
Thank you. My current setting is about 6.86 mm.
I can measure my factory regulator for you tonight, but keep in mind every one is going to be different… You have tolerance stacking of the housing, spool, adjustment screw, locking screw, and the belleville washer stack; because of all those areas of potential variation no two regulators are going to have the same depth for a given pressure. Hopefully a “baseline” measurement gets you within +/- 20 bar. My factory regulator is untouched and was set for 130 bar.
Viewing 4 replies - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
Thank you very much.
But I have gen 1. In esting video, he mention 7.35mm for .25. I think it should be between 6.86mm to 7.35mm for gen 1.