Julien where are you? Did you shoot your Eye Kid!?

Have not heard from you since you got your gun. Hope your not in kid jail or anything. 😆

General Chat

All Replies

Viewing 5 replies - 1 through 5 (of 5 total)

jooleyen

Participant

December 11, 2007 at 9:40 pm

OHHHHHHHHH. OOKAAAY. So I keep following the pattern little by little. Makes sense now. Thanks Adam.

walkonking

Participant

December 11, 2007 at 6:09 pm

Julien….Listen very carefully…..MAKE THE GAPS EVEN…..gently tighten as per gaylord diagram and do each screw a little at a time. Each screw will be tightened a little more each time you follow his pattern. As you make the gaps even on both side it the screws will become snug and then you are done.

jooleyen

Participant

December 11, 2007 at 5:40 pm

I did exactly what I was supposed to do according to Pyramyd Air. It shows the scope mounted on the gun in the picture, but there isn’t another picture showing the other side of the scope. I just can’t find a set of two pictures showing both sides of the scope to see if the gaps between the rings are even.

walkonking

Participant

December 11, 2007 at 4:07 pm

http://www.airgundepot.com/air-rifle-scope-mounting.html

http://www.pyramydair.com/site/articles/scopes-part1/

http://www.pyramydair.com/site/articles/scopes-part2/

jooleyen

Participant

December 11, 2007 at 3:50 pm

Hey! Thanks for caring man. I’ve been shooting my gun and reading the forums every day. I actually just came on here to ask a question…

I can’t get gap (the gap that closes as you tighten the alan screws between the top part of the scope mount ring even on both sides of one ring. One gap is always wider than the one on the other side (left/right) of the scope. Is it supposed to be like this? I’ll post pics if I’m not making any sense.

Thanks

Viewing 5 replies - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.