High tech. pellet trap–>
I’ve seen all flavors of pellet traps and most require too much work if you ask me.
Why couldn’t u shoot at something like this in say 18″x ½” ductile iron?–>
The geometry is good and around here I bet I could find something
close for free/next to nothing scrap. It would be free standing if it had the flanges
and I think noise would be minimal. A chunk like that would prolly weigh ≈250lbs.
All Replies
Viewing 8 replies - 1 through 8 (of 8 total)
What is it called? I was looking for Duct Seal.
No you need the bar stuff in the electrical section
Martin that is a great idea! I was trying to figure a simple way to save the lead from the pellets without making up some kind of thing out of plates and also make it kinda quiet.
Jim.
I looked at the “monkey Shit” at the H.D. It is water base and sticky. Is this the stuff you use?
I still find a junction box at Home Depot with .75″ MDF in the back and loaded with Monkey Shit works great and is totally silent.
Yea-I thought of something like THIS.
That would take a hack like me all day to build something that nice.
Even just a thick metal plate set at an angle would do the trick. Cold Roll scrap around here goes for .59 a pound. You could get a huge plate for cheap. it would get all rusty if you didnt paint it though.
Viewing 8 replies - 1 through 8 (of 8 total)
- You must be logged in to reply to this topic.
Damn, the server is slow!
OK I followed your link. Thanks!