Drilling bushings
I have looked around the forums and I don’t see where a hole size is recommended for drilling the front bushing on the talon SS. I ordered an extra set from AF. I was thinking 1/8 but maybe more smaller holes like 3/32 would be better or smaller yet??
thanks
All Replies
Viewing 3 replies - 1 through 3 (of 3 total)
Thank you.
Hey John….
You will be fine with 1/8 bit. You just want to allow air flow without stressing the bushing.
The SS with stock 12′ barrel are more forgiving than the bushings for the larger O.D. barrels.
Good Luck.
Viewing 3 replies - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
Sharp & Fellows Inc. has been in business as a railroad contracting company since 1877.