ATN COCKING LEVER, INSTALLATION, AND ADJUSTMENTS NEEDED!

Home Forums BullPups Vulcan ATN COCKING LEVER, INSTALLATION, AND ADJUSTMENTS NEEDED!

Viewing 9 posts - 106 through 114 (of 114 total)
  • Author
    Posts
  • #266193
    guykuo
    Participant

    Glad to hear you are getting better. Bronchitis will sure sap your energy.

    At least, glue on the inside surface of the slotted will be invisible and undoable.

    Magnet doesn’t have to touch the sliding piece. As the sliding rod guide gets close to the magnet gets close to the magnet, the guide is pulled off axis towards the magnet. Increased friction between the guide piece and the barrel is what actually does the hold on my setup. It is just enough to keep open with the gun the horizontal position, but not pointed downward. Magnet never directly touches any moving parts.

    #270078
    upperlight
    Participant

    All photos are down.

    Can you please re- upload them!!

    #270101
    upperlight
    Participant

    Installed the lever.
    But there is a problem.
    When cocking with no magazine on, it is very smooth.
    But with the magazine on and trying to load a pellet, it is quite a struggle.

    Any tips :confusedn:

    #270115
    beach-gunner
    Participant

    Upperlight, Review Uncle Hoots installation instructions in this thread and all will be good. Putting the lever parts upside down causes the problem you are experiencing, particularly the cam. I would die-assemble and follow Hoots instructions step by step. Hope this helps! :4:

    #270140
    zonk
    Participant

    It’s so easy even Hoot: figured it out………………………….Just sayin :rofl:

    #270145
    kris
    Participant

    just make sure that during the forward stroke the brass bit into the pellet probe screws into, never comes out of the action.
    FYI it comes out the furthest when you go 90% of the forward motion, then it retracts again.
    obviously there should be no other alignement problems present right
    :rofl:

    if it does come out, it would hit the magazine, not helping things. then the plastic cylinder needs turning on the barrel,the one into the cocking rod screwed in (or the sidelever now)

    bless you

    #270147
    hoot
    Participant

    :hoot:

    We sure lost a lot of information when the bastards at Photobucket.com screwed us by not giving us a courtesy notice they were going to change their policy.

    Hoot:

    #270152
    Anonymous
    Inactive

    It sure did Hoot, it killed a lot of good informative running treads ……..

    ~ Greg

    #270168
    zonk
    Participant

    :angrymob: :angrymob: same here Hoot, SOBs for sure.

Viewing 9 posts - 106 through 114 (of 114 total)
  • You must be logged in to reply to this topic.