9mm

Home Forums General Mods/Machinists 9mm

Viewing 15 posts - 1 through 15 (of 23 total)
  • Author
    Posts
  • #1330
    blodnob
    Participant

    Got a 9mm valve done. Made it a bit bigger than the standard replacement. 7.5mm ID and 10 OD.


    Should go well on this LW polygon

    I pushed a couple of slugs through just to see.

    Atb, Sean

    #32027
    dnc
    Participant

    yay thats mine!

    #32146
    dnc
    Participant

    #32147
    mr-lama
    Participant

    Oooohh shiny. 🙂

    #32149
    walkonking
    Participant

    Killer 😈

    #32150
    mr-lama
    Participant

    No “maybe lama’s mom can polish it” jokes from you guys???

    I’m dissapointed. 😛

    #32151
    akula
    Participant

    Lama; I hate to break the bad news but your mother sold you to ‘sex slavers’. You’ll be picked up in the morning before school. Sorry to tell you this but we all knew. As hard as we tried, we couldn’t talk her out of it.

    Then again, you may get lucky and you’ll only be used for body parts.

    It seems your mother needed the money. Sorry about that.

    Lama; I hope you appreciate a new twist on ‘Yo Mama jokes.’ AKULA

    #32156
    dnc
    Participant

    Cool! So you and your sister are going to be working together now? Tell her that I’ll see her next week.

    (owned)

    #32157
    knifemaker
    Participant

    Oh Man, thats some fantastic looking work!!! Mike

    #32165
    loftus
    Participant

    have you tested the setup yet?i wana know what power it is kicking out with the 7.5mm valve,have you got any heavy slugs to put through it?looks sweet and sexy there on the table tho!

    #32172
    dnc
    Participant

    I haven’t gotten it yet 😥 . It will be here in a few weeks. Thats just another pic he sent me. I’ll give it a really good review once I get it.

    He still has to finish the ldc.

    #32174
    bodhisdad
    Participant

    Your 1 lucky man D, hope you have much fun with your new setup.

    #32175
    blodnob
    Participant

    Am on it as we speak.
    Vent slots done


    Just started the chamber holes, and strugglin a bit. Tryin to keep the weight down and its leaving it all a bit thin. 😥
    Al plod on and see how it goes.
    Sean.

    #32176
    rabbits
    Participant

    once again sean lovely work welldone .wish mine wasn,t on my fac and i could have had a go at the barrels u do 😥

    #32183
    blodnob
    Participant

    Wont be long pal. Just a bit more catching up.

    😳

Viewing 15 posts - 1 through 15 (of 23 total)
  • You must be logged in to reply to this topic.