New Home Forums BullPups EdGun R3 12 FT/lb Tuning Reply To: R3 12 FT/lb Tuning

Thanks oldgoat

I just shot down till it came of the reg and refilled, it was lower this time round at 440 ish so cranked the hst in a little turn that took it to 565 which is good for me. And over about 20 shots it has a spread of about 4fps so will have a check again 2moro.

But i also noticed another problem whilst plinking. My pellets were clipping the baffles, i think the last 2. I did the marker pen trick and i could see it marking it so i drilled out the baffles except the last one or two because my drill bit wouldnt reach to 7mm

So will give it a spin tomoro aswell

The clipping doesnt really bother me as i have had clipping on other silencers such as weihrauch & air arms they are a little easier as they can just be swapped but as this is fixed its a little more awkard but not that bad only took 2mins